|
Accessories Turbine System
|
 |
DISCHARGE VACUUM PUMP
At the end of the run,
this device discharges the water contained in the pipe in order
to allow transport and the pipe unwinding easier. |
 |
SLOW CLOSING
At
the end of the run, this device allows an automatic closing of
the water inlet and makes it possible to stop the pumping plant
in overpressure. |
 |
TWO-SIDES WATER INLET
Pipe
for the machine feeding on two sides, allowing an easy connection
to the hose. |
 |
DISCHARGE VALVE
At
the end of the run, this device allows a large quantity of water,
to discharge causing a line pressure fall, which automatically
stops the pumping plant. |
 |
STEP HYDRAULIC ROTATION
See Features
Turbine System / Hydraulic driven system |
 |
OVERSIZED REAR JACK
See Features
Turbine System / Hydraulic driven system |
|
|
Electronic compensation IRRIGAMATIC
|
|
By-Pass
|
Irrigamatic automatically keeps a constant recovery speed, irrespective of winding diameter, pipe pressure, and tractive force. Once the wished speed has been programmed, Irrigamatic detects the real pipe recovery speed by means of a rear sensor and acting on the by-pass it automatically corrects the recovery speed until obtaining the set value
|
Rear sensor
|
|
IRRIGAMATIC 100
|
- Pipe recovery speed control. |
IRRIGAMATIC 300
|
- It is possible to measure the unwound pipe with unwinding operation end signal (optional) and Wait up to 100 hours without irrigating.
Automatic irrigation start with initial pause from 0 to 99 minutes. It is possible to program up to 4 recovery speeds on the same irrigated area.
Final pause from 0 to 99 minutes. Irrigation stop through a solenoid valve for the slow closing or discharge valve.
Signalling by means of a flash or transmitter for end of run (optional). Digital display of meters to be rewound and time of run. Possible to program using hours instead of meters. |
|
|
|
IRRIGAMATIC 200
|
- Pipe recovery speed control.
- Initial pause.
- Final pause |
|
|
|
|
Irrigamatic/Turbine System Accessories